- Too big resistance of a cable of ignition can cause difficulties at start and interruption of ignition.
- To switch off ignition.
- To remove an ignition cable, for this purpose to remove plugs on the distributor and a candle.
| At the same time to pull for the plug, but not for a cable. |
|
|
- To check resistance between contact of the plug of a cover of the distributor and contact of a tip of a candle. Resistance has to be equal 16 kOhm on meter.
|
- At too high resistance to clear plugs and to repeat measurement, if necessary to replace a cable.
- To bend ignition wires in the field of tips of candles and to check for existence of cracks, if necessary to replace all cables of ignition.
- To connect tips of candles and cables of ignition.
|
|
