Mazda 323

since 1985 release

Repair and operation of the car


Mazda 323

+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
- Coupling
   Removal and installation/check of coupling
   Removal and installation/check of the release bearing of coupling
   Adjustment of a pedal/cable of coupling
   Check/adjustment of a pedal of coupling
   Removal of air from the coupling drive
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and system of steering
+ Brake system
+ Wheels and tires, body, coloring of the car, care of the car
+ System of electric equipment
+ Heater, system of lighting, devices
+ Governing bodies and methods of operation
+ Electric circuits

25215d41

Adjustment of a pedal/cable of coupling

Front-wheel models with the petrol engine to 9/89 g of the issue.

The drive of coupling should be adjusted after each repair of coupling, and also it is regular within maintenance. Adjustment should be checked also at difficulties of inclusion and switching off of coupling.

Adjustment

 PERFORMANCE ORDER

  1. To measure pedal height from the top party of a pedal to a sexual rug. The required value: from 215 to 220 mm.
  1. For adjustment of height of a pedal to remove the lower facing of the dashboard to reach an adjusting bolt. To adjust pedal height rotation of a persistent bolt, previously having weakened a lock-nut (a lock nut). On models with electronic system of injection instead of a persistent bolt the coupling switch is installed. In this case to switch-off the plug and to adjust pedal height rotation of the switch.
  2. To measure a free wheeling of a pedal. For this purpose slightly to press a pedal a hand, considerable resistance will not be felt yet. The required value: from 9 to 15 mm.
  1. If the free wheeling of a pedal does not correspond to the required limits, to open a cowl and to adjust a free wheeling an adjusting nut - In - on a carving element of a cable of coupling. The required value of a gap - And: from 1, 5 to 3, 0 mm (a gap between the lever of the transmission and a finger of a cable).
  1. After adjustment completely to squeeze out a pedal of coupling and to measure switching off height between an overlay of a pedal and a rug. The required value: at least 85 mm. Otherwise to repeat adjustment.