Mazda 323
+ Introduction
+ Petrol engines
+ Engine lubrication system
- Engine cooling system
Contour of cooling liquid
Antifrizny concentrate
Replacement of cooling liquid
Check of tightness of the cooling system
Removal and installation/check of the thermostat
Removal and installation of the water pump
Removal and installation of a radiator
Removal and installation of the motor of the fan
Check of a thermoswitch
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and system of steering
+ Brake system
+ Wheels and tires, body, coloring of the car, care of the car
+ System of electric equipment
+ Heater, system of lighting, devices
+ Governing bodies and methods of operation
+ Electric circuits
|
Replacement of cooling liquid Within maintenance cooling liquid has to be replaced regularly, see the Head Vvedeniye. | If cooling liquid merges within repair, she should be collected as it contains antifrizny and rust-preventing agents. When replacing the water pump, a radiator or head of cylinders cooling liquid should be replaced surely. To apply only company liquid on an etilenglikolevy basis. The concentrate has to be coordinated with aluminum elements. It is impossible to apply cooling liquid on a spirit basis. |
Discharge
|
|
- To unscrew a cover on a radiator.
| To uncover only if the radiator is cooled up to the temperature of hands, differently there is a danger to be scalded by hot cooling liquid. For safety to lay a rag around the union. |
- To substitute under a radiator pure capacity for collecting liquid.
|
|
- To merge cooling liquid from the radiator crane.
|
- To allow cooling liquid to flow down completely.
- To rinse system clear water until in water pollution disappear.
- To screw in a drain stopper on a radiator.
|
|
Filling
|
|
- To fill in cooling liquid through a radiator branch pipe.
- To fill in cooling liquid in a broad tank to the mark FULL. To establish a cover.
- To start the engine and to allow to work 10 minutes on the raised turns. The engine has to reach working temperature, the fan of a radiator has to turn on. During warming up to watch liquid level, if necessary to add.
- After cooling of the engine to check liquid level in a broad tank. If it is required, to add liquid to the mark "FULL".
- To check tightness of the cooling system, especially connections of hoses and a drain stopper, and also the water pump.
|
|
|
|
