Mazda 323
+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and system of steering
+ Brake system
+ Wheels and tires, body, coloring of the car, care of the car
+ System of electric equipment
- Heater, system of lighting, devices
Heater
Fan motor
Removal and installation of the fan of a heater
Control unit of a heater
Adjustment of drives of a heater
Check of the motor of fans/preresistors
Check of the switch of a heater
System of lighting
Table of lamps
Replacement of lamps of external lighting
Headlight
Removal and installation of a headlight
Adjustment of headlights
Removal and installation of back lamps
Devices
Instrument guard
Removal and installation of an instrument guard
Devices
Removal and installation of the radio receiver
Removal and installation of loudspeakers
Removal and installation of the shtyrevy antenna
Replacement of brushes of screen wipers
Removal and installation/adjustment snuffled windscreen washer
Removal and installation of levers of a forward screen wiper
Forward screen wiper
Removal and installation of the motor of a forward screen wiper
Back screen wiper
Removal and installation of the motor of a back screen wiper
Removal and installation of the lever of a back screen wiper
+ Governing bodies and methods of operation
+ Electric circuits
|
Adjustment of headlights The correct adjustment of headlights is of great importance for traffic safety. Exact adjustment is possible only by means of the special device. Therefore only the places of adjustment and a condition necessary for exact adjustment of headlights are described below.
|
|
- In tires there has to be an ordered pressure.
- The driver's seat of not loaded car has to be loaded weighing 75 kg (one person), the gasoline tank has to be full. In conclusion to give a ride to the car several meters that springs correctly were established.
- To install the car on a plain surface.
- To establish adjustment of range of light on "0".
- Headlights have to be regulated only at the turned-on passing beam. The size of an inclination of a ray of light for normal headlights makes 12 cm by 10 m of distance, for fog lights of 20 cm by 10 m of distance.
- Left headlights are represented; on the right screws are located specularly. The cross screw-driver is necessary for adjustment.
|
|
|
|
Как купить качественные входные двери