Mazda 323

since 1985 release

Repair and operation of the car

Ателье для белорусских дизайнеров одежды.

Removal and installation of the motor of a back screen wiper

Removal

PERFORMANCE ORDER

To disconnect a weight cable from the battery.

At the same time data from memory of malfunctions of the engine or a protective code of the radio receiver are erased. Before shutdown of the battery it is necessary to read instructions in the Section Removal also installation of the battery.

To remove the lower upholstery of a door of a back.
To remove the screen wiper lever.
To remove a sealing cap, to unscrew and remove the external plug.
To disconnect the multicontact plug from the motor.
To unscrew the motor from a body, for this purpose to turn out 4 bolts.

Installation

PERFORMANCE ORDER

At installation of the new motor of its steklochistitel it is necessary to bring into final situation at first. For this purpose to connect the plug and to allow to work to the motor about 1 minute. Then to switch off the motor the switch and to allow to be established in final situation. To switch-off the plug.
To screw the motor on a back door with effort of 10 Nanometers.
To install the external plug, to tighten a nut with effort of 5 Nanometers.
To put on a sealing cap.
To install the screen wiper lever.
To connect the plug to the motor.
To connect a weight cable to the battery.
To check work of a screen wiper.
If are available, to determine time on hours and to set a protective code of the radio receiver.
To establish the lower upholstery of a door of a back.

On the homepage