Mazda 323

since 1985 release

Repair and operation of the car

Ателье для белорусских дизайнеров одежды.

Removal and installation of the motor of a forward screen wiper

Removal

PERFORMANCE ORDER

To disconnect a weight cable from the battery.

At the same time data from memory of malfunctions of the engine or a protective code of the radio receiver are erased. Before shutdown of the battery it is necessary to read instructions in the Section Removal also installation of the battery.

To disconnect the multicontact plug from the motor.

To unscrew the motor from a body plate (2 bolts).
To wring out draft-6-from a crank the-5-big screw-driver.

If it is required to remove a crank from the motor, previously it is necessary to mark its situation concerning the holder (tag).

Installation

PERFORMANCE ORDER

At installation of the new motor of its steklochistitel it is necessary to bring into final situation at first. For this purpose to connect the plug and to allow to work to the motor about 1 minute. Then to switch off the motor the switch and to allow to be established in final situation. To switch-off the plug.
To screw a crank on the motor according to the put tag on the holder and to tighten 15 Nanometers with effort.
To establish draft on a crank and to screw the motor by effort of 10 Nanometers.
To connect the multicontact plug.
To connect a weight cable to the battery.
To check work of a screen wiper.
If are available, to determine time on hours and to set a protective code of the radio receiver.

On the homepage