Mazda 323

since 1985 release

Repair and operation of the car


Mazda 323

+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and system of steering
+ Brake system
+ Wheels and tires, body, coloring of the car, care of the car
+ System of electric equipment
- Heater, system of lighting, devices
   Heater
   Fan motor
   Removal and installation of the fan of a heater
   Control unit of a heater
   Adjustment of drives of a heater
   Check of the motor of fans/preresistors
   Check of the switch of a heater
   System of lighting
   Table of lamps
   Replacement of lamps of external lighting
   Headlight
   Removal and installation of a headlight
   Adjustment of headlights
   Removal and installation of back lamps
   Devices
   Instrument guard
   Removal and installation of an instrument guard
   Devices
   Removal and installation of the radio receiver
   Removal and installation of loudspeakers
   Removal and installation of the shtyrevy antenna
   Replacement of brushes of screen wipers
   Removal and installation/adjustment snuffled windscreen washer
   Removal and installation of levers of a forward screen wiper
   Forward screen wiper
   Removal and installation of the motor of a forward screen wiper
   Back screen wiper
   Removal and installation of the motor of a back screen wiper
   Removal and installation of the lever of a back screen wiper
+ Governing bodies and methods of operation
+ Electric circuits

25215d41

Removal and installation of the fan of a heater

From 10/89 g of the issue.

Removal

 PERFORMANCE ORDER

  1. To disconnect a weight cable from the battery.

At the same time data from memory of malfunctions of the engine or a protective code of the radio receiver are erased. Before shutdown of the battery it is necessary to read instructions in the Section Removal also installation of the battery.

  1. To remove a glove compartment, see the Head Kolesa and tires, a body, coloring of the car, care of the car, the Section Panel of Devices / Average the console.
  2. To unscrew the fan-2-case.
  3. To weaken a bracket of fastening and to take out a sealing plate-1-together with the fan block.
  4. To disassemble the block of the fan or to unscrew preresistors.

Installation

 PERFORMANCE ORDER

  1. To establish and screw the fan.
  2. To squeeze a sealing plate and to fix by a fastening bracket.
  3. To connect a weight cable to the battery.
  4. If are available, to determine time on hours and to set a protective code of the radio receiver.

With 9/85 on 9/89 g of the issue.

 PERFORMANCE ORDER

  1. To disconnect a weight cable from the battery.

At the same time data from memory of malfunctions of the engine or a protective code of the radio receiver are erased. Before shutdown of the battery it is necessary to read instructions in the Section Removal also installation of the battery.

  1. To remove facing in the bottom of the dashboard.
  2. To remove a glove compartment, see the Head Kolesa and tires, a body, coloring of the car, care of the car, the Section Panel of Devices / Average the console.
  3. To remove the black steel holder in the top part of a glove compartment.
  4. To remove the air channel between a box of a heater and the block of the fan.
  5. To unscrew 3 nuts of fastening of the case of the fan.
  6. To remove a cable of the inlet air gate.
  1. To disconnect the multicontact plug.
  1. To take out the fan.

Installation

 PERFORMANCE ORDER

  1. To establish and screw the fan.
  2. To connect the multicontact plug.
  3. To establish a cable of the inlet air gate.
  4. To put on the air channel.
  5. To establish the steel holder in a glove compartment.
  6. To establish a glove compartment.
  7. To establish the lower facing.
  8. To connect a weight cable to the battery.
  9. If are available, to determine time on hours and to set a protective code of the radio receiver.