Replacement of brushes of screen wipers Screen wiper elastic bands at an unsatisfactory state should be replaced. On sale there are as the completed brushes (elastic bands with holders), and separately elastic bands. If only the elastic band is replaced, to watch that the holder was not bent.
Removal
|
|
|
|
- To cast away the screen wiper lever up.
|
- To establish a brush at right angle to the lever.
- To press a polymeric lock bracket, to press a brush in the direction of an arrow and to take out from a lever hook.
- To remove a brush through an opening near a polymeric bracket from the lever.
|
|
- To take out an elastic band with brackets from metal fastening.
|
|
|
- To take out the metal holder from an elastic band and to insert into a new elastic band so that dredging of a level was turned to an elastic band and rubber ledges entered grooves.
|
|
|
Holders should not be bent at the same time, if necessary replace. |
|
|
Installation
|
|
|
|
- To insert a new elastic band-21-with a level of fastening-22-into metal brackets of a brush. At the same time to begin with the open party of an elastic band.
|
- To insert a brush into the lever; a screen wiper and to allow to be latched to a polymeric lock bracket.
- To cast away the screen wiper lever into place. At the same time to watch that the elastic band adjoined to glass everywhere.
|
|
|
