Mazda 323

since 1985 release

Repair and operation of the car


Mazda 323

+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and system of steering
+ Brake system
+ Wheels and tires, body, coloring of the car, care of the car
+ System of electric equipment
+ Heater, system of lighting, devices
- Governing bodies and methods of operation
   Before landing in the car
   Running in
   Keys
   Locks of doors
   The uniform (central) locking device (if is available)
   Protection against pranks of children (if is available, only on back doors)
   The power window (if is available)
   Back rotary glasses (on 3-door models)
   Seats
   Adjustment of height of a steering wheel (if is available)
   Seat belts (if is available)
   Door back/trunk lid
   Fuelling
   Mirrors
   Luggage belts
   Trunk lid (if is available)
   Spare wheel
   Dashboard
   - Steering wheel and gear shifting
      Lock of ignition and steering column
      Start of the engine
      Management of RKPP and transfer case
      Operation of the car with the automatic transmission
      Recommendations for economic operation
      Tempostat (switch of the mode of maintenance of constant speed)
      Lighting and light alarm system
      Screen wiper and windscreen washer
      Control panel
      Other devices and equipment
      Heater and ventilation
      The conditioner (if is available)
      Lamps of salon, luggage carrier and lamp for reading (if is available)
      The movable hatch (if is available)
      Start by pushing or towage
      Motive compartment
+ Electric circuits

25215d41

Tempostat (switch of the mode of maintenance of constant speed)

By means of a tempostat, since the speed of 40 km/h, the constant speed of the movement of the car can be supported.

For inclusion press the CRUISE MAIN key dashboards.

For switching off once again press a key.

Installation of desirable speed of the car

 PERFORMANCE ORDER

  1. Accelerate the car to the desirable speed (at least 40 km/h).
  2. Quickly press the SET key on the end of the switch of lighting. You do not hold a key pressed.
  3. Release the accelerator pedal. The established speed will be supported by a constant.

Increase in speed of the car

 PERFORMANCE ORDER

  1. Press the SET key and you hold it pressed. The car will evenly accelerate.
  1. At achievement of desirable speed release a key.

Reduction of speed of the car

 PERFORMANCE ORDER

  1. Install the COAST-RESUME button on the switch of a cleaner and washer in a COAST position and hold in this situation.
  1. Speed will slowly decrease. When desirable speed is reached, release the button. After that again established speed will be supported by a constant.

Switching off

 PERFORMANCE ORDER

  1. Press the CRUISE MAIN key to switch off the mode of maintenance of constant speed.
  2. Slightly squeeze out a pedal of a brake or coupling.
  3. Install the switching lever (on the automatic transmission) in situation "N".
  4. The switch of the mode of constant speed will automatically be switched off when the speed of the car is lower established on 15 km/h.

Repeated inclusion at a speed over 40 km/h

 PERFORMANCE ORDER

  1. Again to include the last established speed, turn the COAST-RESUME button to the right in a RESUME position release the button. The car will automatically accelerate to the last established speed. At a speed below 40 km/h the switch of the mode of constant speed is switched off until speed is more than 40 km/h again. Then again turn the COAST-RESUME button to the right and release it.
  1. The car will automatically accelerate to the speed established before it, and this speed will be supported by a constant.

  • For acceleration when overtaking with the included mode of maintenance of constant speed squeeze out the accelerator pedal as usual. When you release the accelerator pedal again, the speed set earlier will be established again.
  • At strong rise or descent in the mode of maintenance of constant speed the speed of the car can deviate a little.

Do not include the mode of maintenance of constant speed in a dense transport stream which has no constant speed, and on the twisting, ice-covered, crude or slippery road.