The conditioner (if is available) Operation of the conditioner
|
|
- Close side deflectors of fresh air.
- Install the lever of adjustment of temperature in a desirable position.
- Start the engine, press the switch of the conditioner and determine the desirable speed of the fan.
- Adjustment for the maximum power of cooling.
-
Type A — Shift temperature lever completely to the left, install the lever of the fresh / circulating air in a position "" and install the fan speed switch in situation 4.
-
Type B — Press a key of the fresh / circulating air, so that the indicator lit up, and install the fan speed switch in situation 4.
|
|
Conditioner switch
The conditioner joins and switched off by pressing of the switch.
|
|
Even if the conditioner is not used long time, it should be included for several minutes once a week to grease compressor details. |
Type A Type B
Instructions on operation of the conditioner
- If the car was left under direct beams of the sun, before turning on of the conditioner open a window, so that heated air could come out.
- At a rain it is possible to avoid fogging of glasses if to lower temperatures in salon by means of the conditioner.
- At slow trains in a dense transport stream the power of the conditioner is limited because of idling of the engine.
- In this case move on low transfer to improve conditioner power.
- In due time you perform works on check and maintenance, so that it was ready to work at any time.
|
