Removal and installation of the vacuum pump The vacuum pump develops the low pressure necessary for operation of the brake amplifier.
The vacuum pump is on a reverse side of the generator. It is set in motion from a generator shaft through the conducted disk.
Removal
|
|
- To remove the vacuum pipeline, previously having weakened a collar.
- To unscrew the giving oil pipeline. To disconnect a returnable oil pipeline, having weakened previously a collar.
|
|
- To unscrew bolts of fastening of the vacuum pump and to remove the pump about consolidation of round section.
|
|
|
Installation
|
|
- To check consolidation of round section of the vacuum pump for existence of damages, if necessary to replace.
- To install the vacuum pump with consolidation and to tighten fastening bolts with effort of 7 Nanometers.
- To pour in an opening of the vacuum pump of a little engine oil.
- To put on a returnable oil pipeline and to fix by a collar.
- To establish and tighten the giving oil pipeline.
- To install the vacuum pipeline and to fix by a collar.
|
|
|
