At removal of the carburetor a fuel quantity can act. Vapors of fuel are poisonous and flammable therefore to pay special attention to good ventilation of a workplace. To avoid hit of fuel on skin, to work in toplivostoyky mittens. Not to work near naked flame.
Removal
PERFORMANCE ORDER
To disconnect a weight cable from the battery.
At the same time data from memory of malfunctions of the engine or a protective code of the radio receiver are erased. Before shutdown of the battery it is necessary to read instructions in the Section Removal also installation of the battery.
If is available, to unscrew the holder from the air filter.
To remove the gas-3-drive. Previously to mark the adjusting provision of a cover of a cable on a countersupport.
The cable of gas should not be bent, otherwise it will burst in use. Anyway to replace the bent cable.
To disconnect a fuel-supply line-4-and to stop up it, previously having weakened and having shifted a collar back. As a cap the pure bolt of the corresponding diameter can be used.
To disconnect vacuum hoses-5-on the case of the carburetor and to mark them with an adhesive tape.
To disconnect electric connections-6-and-7-and to mark them with an adhesive tape.
To unscrew a nut of fastening of the carburetor and to raise the carburetor-8-.
To remove the heating plug.
To remove a heater-9-and laying.
To cover an inlet pipe with a pure rag that there dirt could not get.
Installation
PERFORMANCE ORDER
To remove a rag, to install the carburetor with new laying on a flange and to screw it.
To connect vacuum hoses according to marking to the carburetor case.
To connect a fuel hose and to fix by a collar.
To install the drive of gas and the starting gate. To clamp a cable cover according to the put marking.
To attach a returnable spring of the lever of a butterfly valve.
If is available, to screw the holder of the air filter.
