Mazda 323

since 1985 release

Repair and operation of the car


Mazda 323

+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
- Power supply system, carburetor, system of injection of fuel
   Rules of purity during the work with a power supply system
   Removal and installation/check of the sensor in the fuel tank
   Removal and installation of the fuel tank
   Removal and installation of the fuel pump
   Removal and installation/check of the fuel pump
   Removal and installation of the air filter
   + Carburetor
   - System of injection of fuel
      System of injection of fuel
      Memory of malfunctions
      Security measures during the work with system of injection
      Idling check
      Verification of the contents WITH
      Check/adjustment of the sensor of a butterfly valve
      Removal and installation/check of the sensor of temperature of cooling liquid
      Check of gates of injection (injectors)
      Removal and installation of gates of injection
      Check of the fuel pump
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and system of steering
+ Brake system
+ Wheels and tires, body, coloring of the car, care of the car
+ System of electric equipment
+ Heater, system of lighting, devices
+ Governing bodies and methods of operation
+ Electric circuits

25215d41 Ателье для белорусских дизайнеров одежды.

Removal and installation/check of the sensor of temperature of cooling liquid

The sensor of temperature of cooling liquid should be checked if the cold engine is badly started or works with interruptions. The sensor of temperature of cooling liquid is in dependence of year of release and the engine or on a reverse side of the engine, or in an inlet collector.

Removal

 PERFORMANCE ORDER

  1. To disconnect the plug of the sensor of temperature of cooling liquid.
  1. To unscrew temperature sensor. To substitute a pure vessel and to collect the following cooling liquid.

Check

 PERFORMANCE ORDER

  1. To suspend temperature sensor in the container with water and to slowly heat water.
  1. To measure temperature sensor resistance by an ohmmeter. For this purpose to connect one plug of an ohmmeter to the case, other plug of an ohmmeter to the sensor plug.
Temperature Resistance in Ohm
- 20 °C 14,2 — 17,8
20 °C 2,2 — 2,7
40 °C 1,0 — 1,3
60 °C 0,50 — 0,65
80 °C 0,29 — 0,35

Installation

 PERFORMANCE ORDER

  1. To install temperature sensor with new laying and to screw 25 Nanometers with effort.
  2. To fill in cooling liquid.
  3. To warm up the engine and to leave to idle, the radiator fan will not turn on yet. To double-check the level of cooling liquid.