Mazda 323
+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and system of steering
- Brake system
Specifications of the brake system
Forward brake
Removal and installation of front brake shoes
Check of thickness / side beating of a brake disk
Removal and installation of blocks of a back disk brake
Removal and installation of a support of a brake
Removal and installation of a brake disk
Removal and installation of back brake blocks / brake drum
Removal and installation of the wheel brake cylinder
Repair of the wheel brake cylinder
Brake fluid
Pumping of the brake system
Replacement of brake pipelines and hoses
Check of the brake amplifier
Removal and installation of the switch of stoplights
Emergency brake
Adjustment of the emergency brake
Anti-blocking system (ABS)
+ Wheels and tires, body, coloring of the car, care of the car
+ System of electric equipment
+ Heater, system of lighting, devices
+ Governing bodies and methods of operation
+ Electric circuits
|
Removal and installation of the switch of stoplights
The switch of stoplights is over a brake pedal on the block of pedals.
Removal
|
|
- To switch off ignition.
- To disconnect the plug from the switch of stoplights.
- To weaken a lock-nut and to unscrew the switch.
|
|
Installation
|
|
- To measure pedal height to a floor. The required value see the Section Specifications of the brake system.
- If height of a pedal does not correspond to the required value, to adjust height and a side play of a pedal in a workshop.
- To screw the switch of stoplights until it concerns a pedal and then to tighten for a half-turn. To tighten a lock-nut.
- To connect the plug and to include ignition.
- To squeeze out a brake pedal, at the same time to ask the assistant to watch stoplights. Already by easy pressing a pedal they have to join, otherwise respectively adjust the switch.
|
|
|
|
