Mazda 323

since 1985 release

Repair and operation of the car


Mazda 323

+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and system of steering
- Brake system
   Specifications of the brake system
   Forward brake
   Removal and installation of front brake shoes
   Check of thickness / side beating of a brake disk
   Removal and installation of blocks of a back disk brake
   Removal and installation of a support of a brake
   Removal and installation of a brake disk
   Removal and installation of back brake blocks / brake drum
   Removal and installation of the wheel brake cylinder
   Repair of the wheel brake cylinder
   Brake fluid
   Pumping of the brake system
   Replacement of brake pipelines and hoses
   Check of the brake amplifier
   Removal and installation of the switch of stoplights
   Emergency brake
   Adjustment of the emergency brake
   Anti-blocking system (ABS)
+ Wheels and tires, body, coloring of the car, care of the car
+ System of electric equipment
+ Heater, system of lighting, devices
+ Governing bodies and methods of operation
+ Electric circuits

25215d41 Ателье для белорусских дизайнеров одежды.

Removal and installation of the wheel brake cylinder

Removal

 PERFORMANCE ORDER

  1. To remove brake shoes.
  2. To weaken a cap nut of the brake pipeline on the wheel cylinder from a reverse side.

Brake fluid will follow at the same time, to substitute specially intended vessel. To follow rules of the treatment of brake fluid, see the Section Pumping of the Brake System.


  1. To turn out 2 bolts of fastening of the-1-wheel cylinder on a reverse side of a board of a brake.
  1. To remove the wheel brake cylinder.
  2. To close a brake hose a suitable stopper to avoid big loss of liquid and penetration of dirt.

Installation

 PERFORMANCE ORDER

  1. To install the wheel cylinder on a board of a brake and to tighten 2 bolts with effort of 10 Nanometers.
  2. To take out a plug and to tighten a cap nut of the brake pipeline with effort of 20 Nanometers.
  3. To establish brake shoes.
  4. To pump over the brake system. At the same time, as a rule, it is enough to pump over only that cylinder where the pipeline was opened. If brake pressure after pumping floats, it is necessary to pump over all system.
  5. It is several times strong to squeeze out a brake pedal. It regulates back brakes.