Mazda 323

since 1985 release

Repair and operation of the car



Mazda 323

+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
- Suspension bracket and system of steering
   Forward suspension bracket — the general information
   Removal and installation of a depreciation rack
   Dismantling of a depreciation rack / removal and installation of the shock-absorber / screw spring
   Check of the shock-absorber
   Removal and installation of the cross lever / replacement of a rubber support
   Check/replacement of a support of the cross lever / rotary fist
   Removal and installation of a power shaft
   Removal and installation of an intermediate shaft
   Check/dismantling of a driving shaft / replacement of cuffs
   Bearing of a forward nave
   Back suspension bracket
   Removal and installation of a back depreciation rack
   Dismantling of a back depreciation rack / removal and installation of the shock-absorber / screw spring
   Cross levers / longitudinal lever / stabilizer
   Check of the hug bearing
   Removal and installation of the hug bearing
   Adjustment of a side play of the hug bearing
   Removal and installation of a nave
   Steering
   Removal and installation of a steering wheel
   Removal and installation of a tip of steering draft
   Removal and installation of a rubber cuff of the steering drive
   Servoupravleniye pump
   Angles of installation of wheels
   Values for check of MAZDA 323
+ Brake system
+ Wheels and tires, body, coloring of the car, care of the car
+ System of electric equipment
+ Heater, system of lighting, devices
+ Governing bodies and methods of operation
+ Electric circuits


25215d41

Bearing of a forward nave

Cars to 9/89 g of the issue and the station wagon model: separate bearing

1 — a wheel nave
2 — a brake disk
3 — a remote element
For adjustment of a preliminary tension of the bearing.
4 — a holder of the external bearing

5 — an external epiploon
6 — an internal epiploon
7 — a holder of the external bearing
8 — an external holder of the bearing
9 — a dustproof plate

Faulty bearings of naves come to light on the following signs: Noise on abrupt turns; the heavy course of a wheel at the released brakes. Bearings sit in a rotary fist so tight that it is possible to remove and establish only by means of a special press. Therefore replacement of hug bearings has to be carried out in the workshop MAZDA. For replacement of hug bearings has to be to remove a rotary fist.

Cars from 10/89 g of the issue, except the station wagon model: bearing block

1 — an epiploon
2 — a nave
3 — a lock ring
4 — the hug bearing

5 — a dustproof plate
6 — a rotary fist
7 — wheel bolts