Mazda 323

since 1985 release

Repair and operation of the car



Mazda 323

+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
- Suspension bracket and system of steering
   Forward suspension bracket — the general information
   Removal and installation of a depreciation rack
   Dismantling of a depreciation rack / removal and installation of the shock-absorber / screw spring
   Check of the shock-absorber
   Removal and installation of the cross lever / replacement of a rubber support
   Check/replacement of a support of the cross lever / rotary fist
   Removal and installation of a power shaft
   Removal and installation of an intermediate shaft
   Check/dismantling of a driving shaft / replacement of cuffs
   Bearing of a forward nave
   Back suspension bracket
   Removal and installation of a back depreciation rack
   Dismantling of a back depreciation rack / removal and installation of the shock-absorber / screw spring
   Cross levers / longitudinal lever / stabilizer
   Check of the hug bearing
   Removal and installation of the hug bearing
   Adjustment of a side play of the hug bearing
   Removal and installation of a nave
   Steering
   Removal and installation of a steering wheel
   Removal and installation of a tip of steering draft
   Removal and installation of a rubber cuff of the steering drive
   Servoupravleniye pump
   Angles of installation of wheels
   Values for check of MAZDA 323
+ Brake system
+ Wheels and tires, body, coloring of the car, care of the car
+ System of electric equipment
+ Heater, system of lighting, devices
+ Governing bodies and methods of operation
+ Electric circuits


25215d41

Removal and installation of an intermediate shaft

All-wheel drive models and models with the DOHC engine

Cars with the DOHC engine of 1,9 l and/or the four-wheel drive have an intermediate shaft between the transmission and the right power shaft at the expense of what length of both power shafts is identical.

1 — a lock ring
2 — an intermediate shaft
3 — an epiploon

4 — an epiploon
5 — the bearing
6 — an intermediate support

Removal

 PERFORMANCE ORDER

  1. To remove the right power shaft.
  2. To unscrew an intermediate support on the block of cylinders and to take out an intermediate shaft from the transmission, at the same time the epiploon should not be damaged.
  3. At damage the bearing and epiploons to vypressovat and replace (it is carried out in a workshop).

Installation

 PERFORMANCE ORDER

  1. To insert an intermediate shaft and to tighten bolts in a certain sequence with effort of 50 Nanometers.
  1. To establish the right power shaft.