Mazda 323
+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
- Suspension bracket and system of steering
Forward suspension bracket — the general information
Removal and installation of a depreciation rack
Dismantling of a depreciation rack / removal and installation of the shock-absorber / screw spring
Check of the shock-absorber
Removal and installation of the cross lever / replacement of a rubber support
Check/replacement of a support of the cross lever / rotary fist
Removal and installation of a power shaft
Removal and installation of an intermediate shaft
Check/dismantling of a driving shaft / replacement of cuffs
Bearing of a forward nave
Back suspension bracket
Removal and installation of a back depreciation rack
Dismantling of a back depreciation rack / removal and installation of the shock-absorber / screw spring
Cross levers / longitudinal lever / stabilizer
Check of the hug bearing
Removal and installation of the hug bearing
Adjustment of a side play of the hug bearing
Removal and installation of a nave
Steering
Removal and installation of a steering wheel
Removal and installation of a tip of steering draft
Removal and installation of a rubber cuff of the steering drive
Servoupravleniye pump
Angles of installation of wheels
Values for check of MAZDA 323
+ Brake system
+ Wheels and tires, body, coloring of the car, care of the car
+ System of electric equipment
+ Heater, system of lighting, devices
+ Governing bodies and methods of operation
+ Electric circuits
|
Removal and installation of a tip of steering draft Removal
|
|
- To weaken nuts of a wheel of the car standing on the earth.
- To change the provision of a disk of a wheel concerning a nave that the balanced wheel could be established in former situation.
- To lift a forward part of the car.
- To remove a wheel.
|
|
- To unscrew a tip of steering draft - And - from the lever of a rotary fist - F-, for this purpose to take out the forelock - E-and to turn off a lock-nut - D-, - In - a lock-nut, - With - steering draft.
|
|
|
- To Vypressovat a tip of steering draft - And - a standard stripper - With-. - In - the lever of a rotary fist.
|
- To weaken a lock-nut and to unscrew a tip from steering draft.
| To mark speed to screw the hinge at installation in the same situation. |
|
|
Installation
|
|
- To screw a tip of steering draft on the written-down speed, not to tighten a lock-nut yet.
- To insert the hinge into the lever of a rotary fist.
- To tighten a lock-nut with effort of 50 Nanometers and to fix by the new forelock. If the forelock is not inserted into an opening, a nut not to weaken, and to tighten further until the forelock rises into place.
- To screw a wheel, considering a tag on a nave. To lower the car and to tighten wheel nuts cross-wise with effort of 100 Nanometers.
- To rock a little the car that suspension bracket elements sat down.
- To check adjustment of a convergence (it is carried out in a workshop) and to tighten a lock-nut on a tip of steering draft with effort of 40 Nanometers.
|
|
|
|
