Mazda 323

since 1985 release

Repair and operation of the car


Mazda 323

+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
- Suspension bracket and system of steering
   Forward suspension bracket — the general information
   Removal and installation of a depreciation rack
   Dismantling of a depreciation rack / removal and installation of the shock-absorber / screw spring
   Check of the shock-absorber
   Removal and installation of the cross lever / replacement of a rubber support
   Check/replacement of a support of the cross lever / rotary fist
   Removal and installation of a power shaft
   Removal and installation of an intermediate shaft
   Check/dismantling of a driving shaft / replacement of cuffs
   Bearing of a forward nave
   Back suspension bracket
   Removal and installation of a back depreciation rack
   Dismantling of a back depreciation rack / removal and installation of the shock-absorber / screw spring
   Cross levers / longitudinal lever / stabilizer
   Check of the hug bearing
   Removal and installation of the hug bearing
   Adjustment of a side play of the hug bearing
   Removal and installation of a nave
   Steering
   Removal and installation of a steering wheel
   Removal and installation of a tip of steering draft
   Removal and installation of a rubber cuff of the steering drive
   Servoupravleniye pump
   Angles of installation of wheels
   Values for check of MAZDA 323
+ Brake system
+ Wheels and tires, body, coloring of the car, care of the car
+ System of electric equipment
+ Heater, system of lighting, devices
+ Governing bodies and methods of operation
+ Electric circuits

25215d41 Ателье для белорусских дизайнеров одежды.

Cross levers / longitudinal lever / stabilizer

Cars with the forward drive

After easing cross/longitudinal levers rubber support can drag on only if the car costs on wheels. Then it is necessary to measure the angles of installation of wheels in a workshop.


1 — a stabilizer nut
To screw so that the carving acted approximately on 18 mm.
2 — a sleeve, the plug, a remote element
3 — a bolt
4 — a cap
5 — a nut
6 — a washer
7 — a bolt

8 — a lock washer
9 — the forward cross lever
10 — the back cross lever
Length changes for adjustment of a convergence, by means of the eccentric plug (to 9/89 g of the issue) or a carving bar (since 10/89 g of the issue).
11 — a bolt, a washer
12 — the longitudinal lever