Mazda 323
+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and system of steering
+ Brake system
- Wheels and tires, body, coloring of the car, care of the car
The sizes of disks and tires/pressure in tires
Designations of disks
Designations of tires
Replacement of wheels
Rules of care of tires
Balancing of wheels
Antisliding chains
Spare wheel
Wear of tires
Body
Removal and installation of a front bumper
Removal and installation of a rear bumper
Removal and installation of a front grille
Removal and installation of side moldings
Removal and installation of a forward wing
Removal and installation/adjustment of a cowl
Removal and installation/adjustment of a door of a back
Removal and installation/adjustment of a door
Upholstery door door/window regulator/glass
Removal and installation of an upholstery of a door
Removal and installation of a glass/window regulator of a forward door
Door lock lock/handle/cylinder
Back door lock / internal drive
External mirror
Removal and installation of glass of a mirror
Panel of devices / average console
Front seats
Removal and installation of a back seat
Back seat
Coloring of the car
Elimination of damages from stones
Rikhtovka body/repair of rusty openings
Preparation for painting
Coloring
Wash of the car
Care of a varnish covering
Protection of the bottom and preservation of cavities
Care of an upholstery
+ System of electric equipment
+ Heater, system of lighting, devices
+ Governing bodies and methods of operation
+ Electric circuits
|
Removal and installation of side moldings Removal
|
|
- Side moldings depending on model can be pasted, established on latches or both. The short element on a forward wing on cars with 9/85 on 8/89 g of the issue fastens on 2 rivets from a wheel arch. From 10/89 g of the issue this molding is pasted, on models the hatchback is screwed together with the side index of turn.
|
|
- To delay a little a molding and to separate glue a sharp knife.
|
| At the same time not to scratch the varnished surface. |
|
|
- Glue connection between a molding and a body can be separated a thin nylon cord (diameter of 0,8 mm). For simplification of work to tie wooden whetstones to both ends of a cord. When the latch comes across, to raise a molding in this place. That glue departed better, to heat a molding the hair dryer to +40 °C.
|
|
|
Installation
|
|
- To clear places of glue on a body gasoline. If the new molding is established, to remove a protective film from noted places.
|
|
- If again the old molding is established, to wash away the remains gluing gasoline and to put a bilateral adhesive tape.
|
|
|
(9/85-9/89 of the issue).
|
|
|
|
- To mark an adhesive tape the adjusting provision of a molding on a body.
|
- To heat a molding and a body approximately to +40 ° — + 80 °C.
- To latch each button blow of a palm.
|
|
From 10/89 g of the issue.
|
|
|
|
- To ground a molding in the designated places.
|
|
|
- To paste a bilateral adhesive tape on the shaded places. To apply polyurethane glue on an internal part.
|
|
|
|
|
