Mazda 323

since 1985 release

Repair and operation of the car



Mazda 323

+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and system of steering
+ Brake system
- Wheels and tires, body, coloring of the car, care of the car
   The sizes of disks and tires/pressure in tires
   Designations of disks
   Designations of tires
   Replacement of wheels
   Rules of care of tires
   Balancing of wheels
   Antisliding chains
   Spare wheel
   Wear of tires
   Body
   Removal and installation of a front bumper
   Removal and installation of a rear bumper
   Removal and installation of a front grille
   Removal and installation of side moldings
   Removal and installation of a forward wing
   Removal and installation/adjustment of a cowl
   Removal and installation/adjustment of a door of a back
   Removal and installation/adjustment of a door
   Upholstery door door/window regulator/glass
   Removal and installation of an upholstery of a door
   Removal and installation of a glass/window regulator of a forward door
   Door lock lock/handle/cylinder
   Back door lock / internal drive
   External mirror
   Removal and installation of glass of a mirror
   Panel of devices / average console
   Front seats
   Removal and installation of a back seat
   Back seat
   Coloring of the car
   Elimination of damages from stones
   Rikhtovka body/repair of rusty openings
   Preparation for painting
   Coloring
   Wash of the car
   Care of a varnish covering
   Protection of the bottom and preservation of cavities
   Care of an upholstery
+ System of electric equipment
+ Heater, system of lighting, devices
+ Governing bodies and methods of operation
+ Electric circuits


25215d41

Removal and installation of an upholstery of a door

Removal for a forward door is described. Removal should be made for a back door as appropriate.

Removal

 PERFORMANCE ORDER

  1. To disconnect a weight cable from the battery.

At the same time data from memory of malfunctions of the engine or a protective code of the radio receiver are erased. Before shutdown of the battery it is necessary to read instructions in the Section Removal also installation of the battery.

  1. At manual adjustment of a mirror to unscrew the driving lever, previously having removed a slip the small screw-driver, see the Head Kolesa and tires, a body, coloring of the car, care of the car.
  2. To remove an overlay of a triangle of a door.
  1. C3/91 of of the issue: To take out an overlay of the button of a lock of a door the small screw-driver and to remove together with the antistatic button. Not to damage an upholstery, to enclose a piece of a cardboard under the screw-driver.

The antistatic button is connected to weight a metal element. Thanks to a contact of this button before an exit it is possible to avoid electric blow by a static charge.


  1. To remove the window regulator handle. For this purpose to enter the screw-driver or a piece of matter between a remote washer and the handle and to press a lock bracket. At the same time to remove the handle from a shaft. If not to reach the handle, the lock bracket can be removed with a curved wire.
  1. To unscrew the internal handle of a door and to disconnect from driving draft.
  2. To unscrew an upholstery of a door and to remove it. To disconnect the plug on the switch of the electric regulator of a mirror.

MAZDA 323 with 9/85 on 9/89 g of the issue.

  1. To wring out a door upholstery from a frame a wide polymeric or wooden wedge. At the same time buttons of fastening are released from captures. To remove an upholstery.
  2. If it is required, to remove a sealing film from a door, at the same time whenever possible not to tear it.

Installation

 PERFORMANCE ORDER

  1. It is careful to paste a sealing film on a frame from below up. The film serves for isolation of salon from drafts, noise and hit of water. At insufficiently good glue layer to use a bilateral adhesive tape. The broken-off film to tape. At significant gaps to replace a film.
  1. To check buttons of fastening of an upholstery of a door. To replace the damaged and bent buttons.
  2. If is available, to connect a cable of an external mirror.
  3. To establish a door upholstery at first from above, then to insert from below and in the field of buttons of fastening to fix by blows of the back of a palm.
  4. To screw a door upholstery.
  5. To insert and screw the internal handle of a door.
  6. To put on the window regulator handle with the inserted lock bracket a shaft so that at the closed window the handle settled down the same as on the antiput door.
  7. At manual adjustment of a mirror to screw the driving lever, then to establish an overlay of bolts, see the Head Kolesa and tires, a body, coloring of the car, care of the car.
  8. To establish an overlay of a triangle of a door.
  9. C3/91 of of the issue: To press and latch in an upholstery an overlay of the locking button of a door with the antistatic button.
  10. To connect a weight cable to the battery.
  11. If are available, to determine time on hours and to set a protective code of the radio receiver.