Rikhtovka body/repair of rusty openings Small dents can be eliminated by means of the leveling hammer and the corresponding manual anvil, at openings from a rust on a body it is recommended depending on the amount of damage or to replace a body detail in a set, or to give a detail to tea leaves.
Rikhtovka
|
|
|
|
- To beat out small dents the leveling hammer, holding at the same time from the opposite side a manual anvil. To knock not too strongly, otherwise metal will be extended and will not get a smooth surface. To work evenly passing from edge to the middle of the damaged place.
|
- It is constant to feel a hand the prepared surface before acquisition of the necessary form by it. Small roughnesses are removed filling subsequently.
- After a rikhtovka carefully to remove a rust and old paint. Or the rough emery paper (grain 120) which is put on a wooden die or the corresponding sanding sheets on a grinding wheel, the decorative moldings and plastic details located to close nearby a protective film that on imprudence not to scratch them.
|
|
|
