Mazda 323
+ Introduction
+ Petrol engines
+ Engine lubrication system
+ Engine cooling system
+ System of ignition
+ Power supply system, carburetor, system of injection of fuel
+ Diesel engine
+ System of production of the fulfilled gases
+ Coupling
+ Manual transmission
+ Automatic transmission
+ Suspension bracket and system of steering
+ Brake system
- Wheels and tires, body, coloring of the car, care of the car
The sizes of disks and tires/pressure in tires
Designations of disks
Designations of tires
Replacement of wheels
Rules of care of tires
Balancing of wheels
Antisliding chains
Spare wheel
Wear of tires
Body
Removal and installation of a front bumper
Removal and installation of a rear bumper
Removal and installation of a front grille
Removal and installation of side moldings
Removal and installation of a forward wing
Removal and installation/adjustment of a cowl
Removal and installation/adjustment of a door of a back
Removal and installation/adjustment of a door
Upholstery door door/window regulator/glass
Removal and installation of an upholstery of a door
Removal and installation of a glass/window regulator of a forward door
Door lock lock/handle/cylinder
Back door lock / internal drive
External mirror
Removal and installation of glass of a mirror
Panel of devices / average console
Front seats
Removal and installation of a back seat
Back seat
Coloring of the car
Elimination of damages from stones
Rikhtovka body/repair of rusty openings
Preparation for painting
Coloring
Wash of the car
Care of a varnish covering
Protection of the bottom and preservation of cavities
Care of an upholstery
+ System of electric equipment
+ Heater, system of lighting, devices
+ Governing bodies and methods of operation
+ Electric circuits
|
Removal and installation/adjustment of a door To remove details in the sequence. Previously to disconnect a weight cable from the battery.
MAZDA 323 from 10/89 g вып
Removal
|
|
- To remove a door upholstery.
- To switch-off the multicontact plug, for example, for the window regulator motor, electrically an adjustable mirror, the central locking device.
- To beat out a pin-2-on a door clamp up by means of the hammer and a drift.
- To unscrew bolts on door hinges. Previously to mark adjusting situation, for this purpose to lead round heads of bolts a felt-tip pen. To remove a door by means of the assistant.
|
|
Installation
|
|
- To insert, level and screw a door.
| If the door needs to be leveled on new, it is necessary to remove the lock previously. |
- To insert from above a door brake pin.
- To connect electric plugs and to establish a door upholstery.
- If it is required, to adjust a door.
- To put the door lock.
|
|
Adjustment of a door
|
|
- The door needs to be adjusted if it is incorrectly closed also after its removal.
- To weaken a door wedge on so many that it could be shifted blows of the rubber hammer. The cross screw-driver or the screw-driver is for this purpose necessary for internal TORX - bolts.
|
|
|
|
